rests alone atop the marine paint
performance pyramid. It is versatile, highly durable and
produces an attractive finish. A high solid formula intended to
provide superior resistance to corrosive chemicals, intense UV,
high impacts, abrasions, saltwater, long term submersion,
grease, oil, solvents and the effects of harsh weather.
Guaranteed to withstand spilled fuel or battery acid for 7 days
with little or no effect! A self leveling formula producing
superior color and gloss retention in the harshest climates. Use
it on virtually any interior or exterior marine surface without
the worry of yellowing or chalking. Acceptable for use above and
below the waterline on prepared steel, aluminum, fiberglass,
wood, concrete or composite material.
Withstands long term submersion, intense UV, heat (500F),
corrosive chemicals, fuels, acids, alkalis and staining agents.
May be wet sanded and buffed. Acceptable for brush, roller-coat
or spray applications. Brush: recommend natural bristle brushes.
Roller: Recommend high quality dense foam roller covers. Spray:
Recommend small-medium size tip. Acceptable for electrostatic
spray. Dry to the touch in 1 hour, recoatable in 6 hours -
temperature dependant. Dries hard in 8 hours. Sand between coats
after 48 hours. Mixing ratio: 7:1 (by volume) with Part B
(Induction Time: 15 minutes). Pot life: 5 hours. Covers 250-300
square feet per gallon. See label and application directions for
further information. Available in 100 colors. Custom colors
available on request for an additional $10.00 per gallon.
Available in gloss or satin.
Recommend applying two or more coats to achieve a minimum DFT of
4 mils. Most applications will require dilution; See (SM-605
Thinner) do not substitute. Cleaner: Recommend
SM-695 Etching Cleaner for
fiberglass, aluminum, concrete and prepared steel surfaces.
Where rust is evident use SM-5679
Rust Converting Cleaner. Primer: Aluminum,
galvanized and Stainless: Use
SM-117 Pre-Wash Primer in combination with any other
Supermarine primer. Fiberglass see
SM-664 Etching Primer or
SM-780 Mono Epoxy Primer. Steel, iron & concrete:
SM-7390 Formula 150 Epoxy Primer
or SM-787 Mono Epoxy Primer.
Wood: See SM-664D Etching Primer.
Slip Resistance: For added slip resistance add 8 ounces
SM-630 Pro-Tex, 1 lb Tred-Tex
or Gaco-Grip. Clean up: Clean with Lacquer Thinner. Refer
to Application Instructions Sheet, Product Data Sheet, label
directions or contact us for additional information.